620-690nm/0.95mW max.
CLASS II LASER PRODUCT
LASER RADIATION - DO NOT
STARE INTO BEAM
CAUTION
>1/4s
Symbols
Read the
operating
instructions
before use.
Disposal of
power tools or
appliances and
batteries
together with
household
waste is not
permissible.
On the tool
Do not stare into the beam.
Laser warning plates for the USA in accordance with
CFR 21 § 1040 (FDA).
On the tool
Laser warning plate in accordance with IEC825 /
EN60825-1:2007
Location of identification data on the tool
The type designation and serial number can be found
on the type identification plate on the tool. Make a
note of this data in your operating instructions and
always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Serial no.:
2. Description
2.1 Use of the product as directed
The PMC 46 is a self-leveling combilaser which allows a single person to level, plumb, align and transfer
right angles quickly and accurately. The tool projects two lines (horizontal and vertical) and five points (above,
below, right, left and line intersection). The lines and line intersection point have a range of approx. 10m. All
other points have a range of approx. 30m. Range depends on the brightness of ambient light.
The tool is designed mainly for indoor use and is no substitute for a rotating laser.
When used for outdoor applications, care must be taken to ensure that the general conditions are similar to
those encountered indoors. Possible applications are:
Marking the position of partition walls (at right angles and in the vertical plane).
Aligning components to be installed or sections of a structure in three axes.
Checking and transferring right angles.
Transferring measuring marks from the floor to the ceiling.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
2.2 Features
The PMC 46 levels itself automatically within a range of approx. 5°.
Self-leveling takes only approx. 3 seconds.
The combilaser gives an “Out of self-leveling range” warning when the self-leveling range is exceeded (the
laser beams blink).
The PMC 46 is characterized by its ease of operation and use, its rugged plastic casing and ease of transport
due to its compact dimensions and light weight.
The tool can be used together with the PMA 31 laser receiver.
In the normal operating mode, the tool switches itself off after 15 minutes. Sustained operating mode can be
activated by pressing and holding the on-switch for four seconds.
en
14
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals