Hilti 427728 Use and Care Manual download pdf (Page 8)

Switch

action

1. Switch Viggel

mt

lz--\/cAuTt0N:

.

Before

plugging

in the tool,

always check to

see

that

the

switch trigger

actuates

properly

and

returns t0 the

"0FF'

oosition

when released.

To

start the t001,

simply

pull

the switch trigger.

Release

the

switch trigger

to stop.

Electric

brake

This tool

is equipped with

an electric blade brake. lf the

tool consistently

fails

to

quickly

stop

blade after switch

trigger

release, have t00l

serviced at a Hilti service

cen-

ter.

The

blade brake

system

is not

a substitute for lower

guard.

NEVER

USE

T00L

WITHOUT A FUNCTI0NING

LOWER

GUARD.

SERIOUS PERSONAL INJURY

CAN

RESULT.

Lighting the lamp

'1.

Lamp

]/i\

lz-.-r

cAlJTl0N:

.

Do

not

apply

impact to

the lamp, which may

cause

damage

or shorted service time t0 it.

.

Do not look in the light

or see the source

of

light

directly.

The lamp lights

up when the tool is

plugged.

The lamp

keeps

on lighting until the tool is

unplugged.

lf the lamp does not light

up, the mains

cord may be

defective. The

lamp

is lit but the tool

does n0t start

even

if the tool is switched

on, the carbon

brushes

may

be

worn

out, the m0t0r

orthe 0N/0FF switch may be defec-

tive.

NOTE:

.

Use a dry cloth to wipe the

dirt

off the lens

of

lamp.

Be

careful not t0

scratch

the lens

of

lamp,

or it may low-

er the illumination.

f-t

Lr=-}l

cAUTlON:

.

Ah^ays

be sure that the tool is

switched off and unplugged

before

carrying out any work on the to0l.

Hex

wrench storage

1. Hex wrench

2. Protrusion

Hex wrench is

stored on

the

tool. To remove hex wrench,

rotate it

toward

yourself

and

pull

it

out.

To install hex wrench,

place

it on the handle

and

turn it

until

it

comes into contact with the

orotrusion on the

handle.

Removing or installing saw

blade

1. Hex wrench

2. Shaft lock

GAUTIOl,I:

.

Be

sure the blade is installed

with

teeth

pointing

up at

the front

of

the tool.

.

Use only the Hilti wrench to

install or

remove the blade.

To remove the

blade.

oress

the shaft lock so

that the

blade cannot

revolve

and use

the hex wrench to loosen

the

hex

bolt counterclockwise.

Then remove

the hex

bolt,

outer flange

and blade.

To install

the blade, follow

the removal

procedure

in

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments