Hilti 3482514 Use and Care Manual download pdf (Page 36)

8.6 Checking the power tool after care and

maintenance

After carrying out care and maintenance work on

the power tool, check that all protective and safety

devices are fitted and that they function faultlessly.

9. Troubleshooting

Fault Possible cause Remedy

The power tool doesn’t run.

The battery is discharged or fitted

incorrectly.

The battery must be heard to engage

with a double click or, respectively,

needs to be charged.

Electrical fault. Remove the battery from the power

tool and contact Hilti Service.

The battery is too hot or too cold. Bring the battery to the recom-

mended working temperature.

The power tool doesn’t run

and 1 LED blinks.

The battery is discharged.

Change the battery and recharge the

discharged battery.

The battery is too hot or too cold. Bring the battery to the recom-

mended working temperature.

The power tool doesn’t run

and all 4 LEDs blink.

The power tool has been overloaded. Release the control switch and

press it again.

The overheating prevention cut-out

has been activated.

Allow the power tool to cool down.

Clean the ventilation slots.

No hammering action. The power tool is too cold. Allow the power tool to warm

up to the minimum operating

temperature.

See section: 7.2.1 Working at low

temperatures

The function selector switch is set

to “Drilling without hammering”.

Set the function selector switch to

“Hammer drilling”.

The forward/reverse switch is set to

reverse rotation.

Set the forward/reverse switch to

forward rotation.

The control switch can’t be

pressed, i.e. the switch is

locked.

The forward / reverse switch is in

the middle position (transport lock

engaged).

Push the forward / reverse switch

to the left or right.

The drive spindle doesn’t

rotate.

The permissible operating tempera-

ture of the power tool’s electronics

has been exceeded.

Allow the power tool to cool down.

The permissible battery operating

temperature has been exceeded.

Bring the battery to the recom-

mended working temperature.

The battery is discharged.

Change the battery and recharge the

discharged battery.

The power tool switches itself

off automatically.

The overload cut-out has been

activated.

Release the control switch, reduce

the load on the power tool and then

press the switch again.

1 2 ... 31 32 33 34 35 36 37 38 39

Comments to this Manuals

No comments

Hilti 3482514 Use and Care Manual Page 36

Comments to this Manuals

Related products and manuals for Cordless screwdrivers Hilti 3482514