Hilti 3490197 Use and Care Manual download pdf (Page 14)

If you disconnect a battery from the power tool for

transport or storage, make sure that the battery con-

tacts are not short-circuited. Remove loose metal

items such as screws, nails, clamps, loose screw-

driving bits, wires or metal cuttings and chips from

the toolbox or transport container, or prevent these

items from coming into contact with the battery.

Observe national and international transport regula-

tions when shipping batteries (transportation by road,

rail, sea or air).

7. Operation

NOTE

If the blade has jammed, the tool will not restart

by itself after pressure on it has been released. The

switch-on interlock and the on/off button must be

pressed again to restart.

NOTE

The chip collector must always be fitted when the tool

is in use.

CAUTION

Wear protective gloves. The cutting edges of the

saw blade and cut edges of the workpiece are sharp.

These sharp edges present a risk of injury.

CAUTION

Wear protective glasses and a dust mask. The

sawing operation swirls up dust and chips into the

air. The dust and chips may be harmful to the eyes

and respiratory system.

CAUTION

Wear ear protectors. The power tool and the sawing

operationgeneratenoise. Exposureto noise cancause

loss of hearing.

CAUTION

Secure the workpiece. Use clamps or a vice to

secure the workpiece. This will help to prevent vi-

bration.

CAUTION

Do not saw off very narrow strips. Narrow strips

may be caught by the blade and pulled in, causing

jamming, or may be thrown out, presenting a risk of

injury.

CAUTION

When sawing, take care to ensure that there are no

flammable materials in the vicinity and that no hot

metal cuttingsfall onto highly flammablematerials.

CAUTION

Do not use coolants or lubricants when sawing.

7.1 Changing the saw blade

CAUTION

Wear protective gloves when changing insert tools.

The tool, the clamping flange and the clamping screw

get hot.

CAUTION

Check that the blade to be fitted complies with the

technical requirements and that it is well sharp-

ened. A sharp saw blade is an essential requirement

for a perfect cut.

7.1.1 Removing the saw blade 2

1. Pull the battery out of the power tool.

2. Press the drive spindle lockbutton and hold it in

this position.

3. Turn the saw blade clamping screw with the hex.

socket wrench until the locking pin engages fully.

4. Release the clamping screw by turning the

wrench further clockwise.

5. Remove the clamping screw from the outer

clamping flange.

6. Open the pivoting guard by swinging it to the

side and then remove the saw blade.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments

Hilti 3490197 Use and Care Manual Page 14

Comments to this Manuals

Related products and manuals for Power tools Hilti 3490197