Hilti TE 2-S Operations Instructions download pdf (Page 10)

Assembly

It is essential that the safety precautions printed in these

operating instructions are read and observed.

Fitting the side handle

1.Unplug the tool from the mains socket.

2.Release the side handle clamping band by turning

the handle in a counter-clockwise direction.

3.Fit the side handle clamping band over the chuck

and onto the cylindrical section at the front end of

the tool.

4. Pivot the side handle into the desired position.

5.Tighten the side handle securely to prevent inad-

vertent movement.

Check that the side handle is seated securely .

The supply voltage must correspond to the information

on the type plate.

If extension cords are used: Only extension cords of a

type approved for the intended use and of adequate cross

section may be used. Failure to observe this point may

The tool is designed for the following uses:

Use Required insert tools Diameter range

TE2 / TE2-S / TE 2-M:

Hammer drilling in concrete, Drill bits with TE-C connection end Drilling in concrete:

masonry and natural stone – Short hammer drillbits Anchor holes of 4–22 mm (

″–

″) dia.

– Long hamer drill bits Through holes of 4–22 mm (

″–

″) dia.

TE2-S:

Drilling with precision Drill bits with TE-C connection end Drilling in brittle materials:

hammering action in perforated – TE-C hammer drill bits Anchor holes of 4–22 mm (

″–

″)dia.

brick, tiles and marble – Thin-barrel core bits Cutting sockels of 25–68 mm (1″–2

″) dia.

TE2 / TE2-S:

Drilling in wood, drywall panels Quick-release chuck

and metal with TE-C adaptor

for insert tools

with cylindrical shank or hexagonal shank

for rotary-only drilling

Wood drill bits 4–20 mm (

″–

″)dia.

Metal drill bits 3–13 mm (

″–

″) dia.

Hole saws 25–68 mm (1″–2

″) dia.

TE2-M:

Drilling in wood, drywall panels, Interchangeable quick-release chuck

tiles and metal for insert tools

with cylindrical shank or hexagonal

shank for rotary-only drilling:

Wood drill bits 4–10 mm (

″–

″) dia. in 2nd gear

10–20 mm (

″–

″) dia. in 1st gear

Metal/stepped drill bits 3– 8 mm (

″–

″) dia. in 2nd gear

8–13 mm (

″–

″) dia. in 1st gear

Hole saws 25–68 mm (1″–2

″) dia. in 1st gear

Variable speed switch

Rotary-only drilling mode

Gearing and hammering mechanism with permanent

grease lubrication

Pivotable side handle (360°)

Mechanical depth gauge

Interface for quick-release chuck (TE2-M)

Precision hammering action (TE2-S)

High spindle speed without hammering action (TE2-M)

Lockbutton for sustained operation

Right of technical changes reserved

Printed: 07.07.2013 | Doc-Nr: PUB / 5070816 / 000 / 00

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Comments to this Manuals

No comments

Hilti TE 2-S Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Rotary hammers Hilti TE 2-S