*2049115*2049115PM 2-PBedienungsanleitung deOperating instructions enMode d’emploi frIstruzioni d’uso itManual de instrucciones esManual de instru
R = x (2)30RH [ft](d1 + d2) [inch]4R = x (1)10RH [m](d1 + d2) [mm]46. Pivot the tool through 90°.NOTE The lower plumb beam must remain onthe center of
9. TroubleshootingFault Possible cause RemedyThe tool cannot be switchedon.The battery is exhausted. Replace the battery.The battery is inserted the w
Dispose of the batteries in accordance with national regulations.11. Manufacturer’s warrantyHilti warrants that the tool supplied is free of defectsin
13. EC declaration of conformity (original)Designation: Point laserType: PM 2-PYear of design:2012We declare, on our sole responsibility, that thispro
*2049115*2049115Hilti CorporationLI-9494 SchaanTel.: +423/234 21 11Fax: +423/234 29 65www.hilti.comHilti = registered trademark of Hilti Corp., Schaa
PIWPP´:::KLOWLFRP2345
ORIGINAL OPERATING INSTRUCTIONSPM 2-P point laserIt is essential that the operating instruc-tions are read before the tool is operatedfor the first ti
620-690nm/0.95mW max.CLASS II LASER PRODUCTLASER RADIATION - DO NOTSTARE INTO BEAMCAUTION>1/4sSymbolsRead theoperatinginstructionsbefore use.Dispos
2.3 Information displayed during operationLEDThe LED doesn’t light.The tool is switched off.The LED doesn’t light.The batteries are exhausted.The LED
4. Technical dataRight of technical changes reserved.Range of the points 30 m (98 ft)Level of accuracy setting at room temperature +24°C (75 °F)1±3.0
and do not use it in damp or wet conditions. Donot use the tool where there is a risk of fire orexplosion.j) Maintain the machine carefully. Check for
g) Do not dischargethe batteriesby short circuitingas this may cause them to overheat and presenta risk of personal injury (burns).h) Do not attempt t
Comments to this Manuals